.

Gcode de début Cura

;**************************************************************************************
; Move to the Home position (0 0 0) XY first than Z axis
;**************************************************************************************
G28 X0 Y0 ;Move X/Y to min endstops
G28 Z0    ;Move Z to min endstops
G29       ;BL-Touch auto-level
;**************************************************************************************
; Purge la buse et la nettoie avant de lancer l'impression
;**************************************************************************************
G0 X0 Y10 F6000  ; Positionne la buse en (X0 Y10)
G0 Z0.15         ; Descend proche du lit chauffant
G92 E0           ; Initialise la longueur de filament extrude
;G1 E5 F6000     ; Extrude 5mm de filament
G1 X100 E25 F500 ; Extrude 25mm de filament sur une ligne de 10cm
G92 E0           ; Initialise la longueur de filament extrude
G1 E-1 F500      ; Retracte un peu le filament
G1 X80 F6000     ; Quitte rapidement la ligne de filament
G1 Z0.3          ; Monte la buse et commence a imprimer
M117 Printing... ; Put printing message on LCD screen

Gcode de fin Cura

;**************************************************************************************
; Stop hotend and hotbed
;**************************************************************************************
M104 S0		;extruder heater off
M140 S0		;heated bed heater off (if you have it)
;**************************************************************************************
; Retract and move the hotend up 20mm
;**************************************************************************************
G91		;relative positioning
G1 E-1 F6000	;retract the filament of 1mm before lifting the nozzle to release some of the pressure
G1 Z+20 E-3 X-20 Y-20 F6000	;move Z up 20mm and retract filament even more
;**************************************************************************************
; Move hotend to (0  0) and advance bed to front
;**************************************************************************************
G28 X0 Y0	;move X/Y to min endstops so the head is out of the way
G0 Y180 F3500	;bring back plate to make removal easier
;**************************************************************************************
; Stop the motors and the fan
;**************************************************************************************
M84		;steppers off
G90		;absolute positioning
M107		;fan off